The current of photovoltaic panels in parallel is small

Thus the effect of parallel wiring is that the voltage stays the same while the amperage adds up. Photovoltaic solar panels generate a current when exposed to sunlight (irradiance) and we can increase the current output of an array by connecting the pv panels in parallel.

The connection of multiple solar panels in parallel arises from the need to reach certain current values at the output, without changing the voltage. In fact, by wiring several solar panels in series we increase the voltage (keeping the same current), while wiring them in parallel we increase the current (keeping the same voltage).

The following figure shows solar panels connected in parallel configuration. If the current IM1 is the maximum power point current of one module and IM2 is the maximum power point current of other module then the total current of the parallel-connected module will be IM1 + IM2.

If the parallel connected pv panels are of different wattages and ratings, then both the voltage and current are limited to the lowest values, reducing the efficiency of the parallel connected array even at maximum irradiance. Voltage mismatch must be avoided in parallel connections.

Connecting PV panels together in parallel increases current and therefore power output, as electrical power in watts equals “volts times amperes” (P = V x I). Note that photovoltaic panels DO NOT produce or generate alternating current, (AC) that you find in your homes. That is, alternating current solar panels dos not exist.

On the other hand, if our two solar panels have both different wattage and different voltage, then parallel connection is not possible, since the panel with the lowest voltage would behave like a load, and would begin to absorb current instead of producing it, with the relative consequences. What if we have one 12V panel and two 6V panels?